Enterasys Networks CSX7000 User Manual download pdf (Page 528)

100

101

USER’S GUIDE

528 CyberSWITCH

Semipermanent. Device "x" disconnected by admin

The administrator has issued a

disc device <device name>

command. Therefore, the system

will not attempt to call the indicated device again. Issuing the

call device <device name>

command will make device “x” semipermanent again.

Semipermanent. Device "x" has a smaller Initial Data Rate than Base Data Rate. No connection made.

The semipermanent feature will make enough calls to meet but not exceed the device’s Initial Data

Rate. In this case, the Base Data Rate (normally 56 or 64 Kbps) is larger than the device’s Initial Data

Rate. The semipermanent feature cannot make any calls, or it will exceed the Initial Data Rate.

Reconfigure your data rates.

Semipermanent. Device "x" has had "y" bandwidth drops within "z" seconds. This device is considered to

have failed remote authentication.

Because the local system cannot always be aware of remote authentication failures, and because

there is no way to recognize remote authentication failures in the system once the remote end is

authenticated, the semipermanent feature will try to determine them by detecting excessive remote

bandwidth drops. The remote device must drop a call 10 times within a 10 minute period to trigger

this event.

Will try again in "w" minutes.

This will be displayed directly beneath the above message if a Session Interval is

configured for the device.

Semipermanent. Device "x" reconnected by admin.

The administrator has issued the

call device <device name>

command after issuing the

disc device <device name>

command. This restarts the semipermanent feature for the

indicated device.

Severe congestion CLLM received for DLCI <dlci index>

A CLLM message was received indicating severe congestion may be expected on the PVC

associated with the indicated DLCI.

Signal for unknown CallCmd task: <task Id>

Contact your Distributor or Customer Support.

SIG_notify Failure. Called Session is not Active.

An error has been detected in the R2 signaling procedure, and will typically result in a failed call.

The error was due to unrecognizable or incorrect information. If problem persists, contact your

Distributor or Customer Support.

<slot #, port #> Cfg Error

Line vs. adapter configuration error. A line is configured for port <port #> that does not exist on

the adapter in slot <slot #>.

1 2 ... 523 524 525 526 527 528 529 530 531 532 533 ... 728 729

Comments to this Manuals

No comments

Enterasys Networks CSX7000 User Manual Page 528

Comments to this Manuals