Enterasys Networks CSX7000 User Manual download pdf (Page 202)

100

101

USER’S GUIDE

202 CyberSWITCH

Bridging with PPP Bridge Devices (Using BCP)

To allow a PPP Bridge device to connect to the CyberSWITCH, you must have Bridging enabled.

For each PPP Bridge device using this type of connection, you may need to enter a PAP Password

or a CHAP Secret, and a Calling Line Id.

The following table identifies the configuration requirements for possible security options for PPP

Bridge Devices.

Note: If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAP

Secret must be entered for both the remote device and for the CyberSWITCH. Refer to the

System Information for information regarding the System Secret. If Outbound

Authentication has been disabled, a CHAP Secret is not required for the remote device.

IP Routing with PPP Bridge Devices (Using BCP)

To allow devices to connect to the CyberSWITCH using IP routing through a PPP Bridge device,

you must configure a RLAN IP Network Interface. IP routing must also be enabled. For each PPP

Bridge using this type of connection, you may need to enter the Device Name, a Calling Line Id, a

PAP Password or a CHAP Secret, and an IP (Sub) Network Number.

Security Mode Configuration On-node Device Table Configuration

Data

Calling Line Id PAP or CHAP

Security

Calling Line Id PAP Password or

CHAP Secret

Disabled Enabled Not Requested Required

Enabled Enabled Optional per

device entry

Required

Enabled Disabled Required Optional

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 728 729

Comments to this Manuals

No comments

Enterasys Networks CSX7000 User Manual Page 202

Comments to this Manuals