Enterasys Networks CSX7000 User Manual download pdf (Page 595)

100

101

Central Site Remote Access Switch 595

YSTEM

OMMANDS

Call Control Commands

Calling <phone number> at <data rate>, device PPP

The phone number will show what is sent to the switch. Any imbedded dashes will have

been removed. The data rate that is used is displayed. If an invalid data rate is entered, the

default of 56 Kbps will use used. Because dial out is only provided for PPP devices, the

device type is always PPP.

One of the following messages will then be displayed:

Call initiated

This response indicates that a

call peer

request was performed. This does not always

imply that a request reached the telephone switch.

Call attempt failed

This response indicates that the request could not be executed.

Note: The

call peer <phone number>

command will not work under the following

conditions:

If PAP or CHAP is enabled and Outbound Authentication is disable, or, if the only

security enabled is CLID. In either case, the CyberSWITCH will not be able to

authenticate the remote peer. A message will appear in the log to indicate this. Use the

call device <device name>

command instead.

disc device <device name>

Disconnects all calls to the specified device. To obtain the device name, enter the Manage Mode

and issue the

device

command. Note that the device name is case sensitive.

In response to the

disc device

command, one of the following responses will be displayed:

Disconnecting <device name>

Indicates that the disconnect process has been initiated for the indicated device.

No active connection to <device name>

Indicates that the device that you are attempting to disconnect has no active connection.

The

or the

command can be used to view the active connections.

<device name> could not be found in the Device Table

Indicates that the device name could not be found in the table of configured device names.

More than one match for <device name> found in the Device Table

Displayed if you enter just part of a device name and that part could specify more than one

device name. You will be prompted to enter the device name again, in a more specific

manner. For example, if

call device Sch

is entered, and there is a device configured

with the name Schultz, and a device configured with the name Schmidt, this message

would be displayed. You would then need to enter at least

call device Schu

successfully initiate a call to the device Schultz.

Re-enter the name, or <RET> to cancel

The device name must be re-entered.

1 2 ... 590 591 592 593 594 595 596 597 598 599 600 ... 728 729

Comments to this Manuals

No comments

Enterasys Networks CSX7000 User Manual Page 595

Comments to this Manuals