Enterasys Networks CSX7000 User Manual download pdf (Page 525)

100

101

Central Site Remote Access Switch 525

YSTEM

ESSAGES

System Message Summary

RBS: Encountered unknown source ID.

RBS_out_SM<channel #>: NO Dial Digits supplied.

RBS: Received unknown primitive from CC.

RBS: Received unknown primitive from L1.

RBS: Received unknown primitive from ME.

RBS: Received unknown primitive from RBS.

The above Robbed Bit Signaling messages indicate that the system software sent a message to the

RBS state machine that the state machine was unable to recognize or the information was incorrect.

If this message is displayed in the log messages, contact your Distributor or Customer Support.

RBS: LIF_AddTimer failure.

An event occurred that the RBS task interpreted as a call signaling event, but layer 1 is not properly

initialized. Ensure that an ISDN line is not plugged into a RBS card.

RBS: LIF_GetBuffer failure.

RBS: Unable to send host CALL_CLEARED.

RBS: Unable to send host CALL_CONNECTED.

RBS: Unable to send host CALL_REQUEST_ACK.

RBS: Unable to send host HOST_CALL_INDICATION.

RBS: Unable to send host REMOTE_DISCONNECT

RBS: Unable to send package to host.

The above Robbed Bit Signaling messages indicate that the WAN card is not communicating

properly with the host, probably due to a card failure. Contact your Distributor or Customer

Support.

RBS_out_SM<channel #>: Timeout waiting for WINK.

The system went off-hook and the switch never “winked” back, going off-hook for a specified

amount of time and then returning to on-hook. The switch must wink back in order to tell the

system to start dialing. Contact the telephone company and ensure that the line is configured for

wink-start.

RBS: Unexpected event chan = <channel #>, state = <state ID>

An illegal signaling event occurred in the RBS task on the specified channel. Ensure that the line is

configured correctly and that it is using the expected RBS protocol. Excess noise on the line may

also cause this event.

Read 0 bytes from file <file name> for WAN card in slot <slot #>

If seen repeatedly, the above message indicates a problem with your hard drive. Contact your

Distributor or Customer Support.

Ready for XModem Download - <ESC> to abort

The user has requested an attempt to UPDATE the system software, or it was not possible to Boot

the system the last time it was attempted.

Reattempting to Install File Set into Flash Memory

The SSB is re-attempting to install the FileSet. The Flash File System may have been corrupted when

attempting to install the FileSet the first time. In the meantime, the Flash File System has been

formatted.

Rebooting...

The system is going to wait until the WatchDog timer expires, which causes the entire system to

reboot.

1 2 ... 520 521 522 523 524 525 526 527 528 529 530 ... 728 729

Comments to this Manuals

No comments

Enterasys Networks CSX7000 User Manual Page 525

Comments to this Manuals