Enterasys Networks CSX7000 User Manual download pdf (Page 511)

100

101

Central Site Remote Access Switch 511

YSTEM

ESSAGES

System Message Summary

[IP] WAN (Direct Host) Interface for network <network #> on LAN port <port #> initialized successfully

This message is posted when WAN (Direct Host) interface for the indicated network is initialized

successfully.

[IPCP] Invalid pre-configured IP address <IP address> for <device name>, ignored

There is a configured IP address for the remote device in the Device Table, but the IP address does

not belong to any configured WAN interfaces. Check the configuration. You will most likely need

to add another WAN interface.

[IPCP] IP Address Pool - Out of IP addresses

IPCP needed to allocate an IP address from the IP address pool, but there were no IP addresses

available in the IP address pool. You may need to add more IP addresses to the pool.

[IPCP] Option Negotiation Failure, Non-Convergence detected

IPCP is terminated because an agreement could not be reached on the details of protocol. Refer to

the specific documentation for the device in question to determine if it is configured correctly.

Then, contact your Distributor or Customer Support.

[IPCP] Remote device does not negotiate IP address

Please configure IP address for the device <device name>

The IP address for the remote device is either improperly configured, or not configured at all.

Check configuration and adjust.

[IPFILT] Filter “abcd” does not exist, ignored by application point “xyz”

This particular error message detects that an attempt has been made to apply a non-existent filter.

In theory, this can only happen if someone manually modifies a configuration file (other than

through CFGEDIT or Manage Mode).

[IP Host] Call Dropped: ID Response was not received from remote

The system did not receive a valid identification exchange from the remote IP Host. The system has

rejected the incoming call. Refer to the Quick Start for proper setup of your particular device.

[IP Host] Call Dropped: XID was not received from remote

The system did not receive a valid identification exchange from the remote IP Host. The system has

rejected the incoming call. Refer to the Quick Start.

[IP Host] Security Rejection - Digit string wrong length

The system did not receive a valid identification exchange from the remote IP Host. The

Identification digit string from the remote device was not of an appropriate length. This string must

be a 24 character string of ASCII digits (0-9), which is blank padded. The system has rejected the

incoming call.

[IP Host] Security Rejection - Invalid Security ID <Id string>

The system has received an IP Host Id, <Id string>, from a remote device that is not configured in

the Device List. The system has rejected the incoming call. Verify that the IP Host ID in the Device

List information is identical to the IP Host Id configured in the remote device.

[IP Host] Security Rejection - Security ID cannot be validated with Authentication Server

The System authentication type is configured to obtain device information off-node, for example

from a RADIUS server; however, such transactions are not yet supported when IP Host ID Security

is enabled.

1 2 ... 506 507 508 509 510 511 512 513 514 515 516 ... 728 729

Comments to this Manuals

No comments

Enterasys Networks CSX7000 User Manual Page 511

Comments to this Manuals