Enterasys Networks C2K122-24 User Manual download pdf (Page 35)

Installing the Switch on a Flat Surface

SecureStack C2 Installation Guide 3-5

ToremoveanXFPfroma portslot,referbacktoFigure 3‐1,andproceedasfollows:

1. Attachyourantistaticwriststrap(refertotheinstructionsinyourantistaticwrist

strappackage)beforeremovingtheXFP.

2. RemovethecableconnectedtotheXFP.

3. LocatetheXFPwirehandleandpulldownon

ittoreleasetheXFP.

4. GraspthesidesoftheXFPand pullitstraightoutoftheportslot.

IfstoringorshippinganXFP,whichhasafiber‐opticconnector,insertitsprotectivedust

covertoprotecttheendsofthefiber‐opticfibersfromdustorcontamination.

Installing the Switch on a Flat Surface

Wheninstallingtheswitchonaflatsurface,theinstallationoftherubberfeetis

recommendedtopreventtheswitch fromslidingonaflatsurface.Installingtherubber

feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed

to“Installingthe

RubberFeet”instructionsbelow.Forinstructionstorackmountthe

switch,proceedto“RackMountingtheSwitch”onpage 3‐7.

Installing the Rubber Feet

Toinstalltherubberfeet,refertoFigure 3‐2andproceedasfollows:

1. Placetheswitchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe

chassis.

2. Removethefourrubberfeetfromtheirplasticbagintheshipping box.

3. Locatethefourmarkedlocationson

thebottomfourcornersofthechassis.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 69 70

No comments

Enterasys Networks C2K122-24 User Manual Page 35