Enterasys Networks C2K122-24 User Manual download pdf (Page 34)

Installing Optional XFPs

3-4 Hardware Installation

Installing the XFP

ToinstallanXFPthathasanLCconnector,refertoFigure 3‐1,andproceedasfollows:

1. HoldtheXFPwiththetopsidepositionedasshown,andtheedgeconnectorfacing

theportslot.

2. AligntheXFPwiththeportslot.

3. PushtheXFPintotheportslotuntiltheXFP

“clicks”andlocksintoplace.

Figure 3-1 XFP with LC Connector

Removing the XFP

1 XFP 4 Port slot

2 XFP,

top side 5 Protective dust cover

3 Edge connector (insertion side) 6 Wire handle (for XFP release)

2K122-24

Caution: Do NOT remove the XFP from the port slot without releasing it. The XFP is

released by pulling down on its wire handle. Attempting to remove the XFP without

releasing it can damage the XFP.

The XFP and its host switch are sensitive to static discharges. Use an antistatic wrist strap

and observe all static precautions during this procedure. Failure to do so could result in

damaging the XFP or host switch. Always leave the XFP in the antistatic bag or an

equivalent antistatic container when not installed.

Precaución: NO quite el XFP de la ranura sin antes abrir la traba ubicada en la parte

frontal del XFP. Si lo hace, puede dañar el XFP, puesto que es muy sensible a las

descargas de electricidad estática, al igual que el dispositivo host. Utilice la pulsera

antiestática y tome todas las precauciones necesarias durante este procedimiento. Si no

lo hace, pude dañar el XFP o el dispositivo host. Mientras no esté instalado, mantenga el

XFP en su bolsa antiestática o en cualquier otro recipiente antiestático.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

No comments

Enterasys Networks C2K122-24 User Manual Page 34