Enterasys Networks C2K122-24 User Manual download pdf (Page 48)

Connecting to Console Port for Local Management

3-18 Hardware Installation

Connecting to a VT Series Terminal

ToconnectaVTSeriesterminaltoanEnterasysswitchConsoleport(Figure 3‐10),usea

UTPserialinterfacecableterminatedwithaDB9femaleconnectorandaDB25female

connectorandproceedasfollows:

1. ConnecttheDB9femaleconnectoratoneendofcabletotheConsoleporton

the

Enterasysswitch.(IfthereisaswitchdesignatedastheManager,connecttoits

Consoleport.)

2. PlugtheDB25femaleconnectorattheotherendofthecableintotheportlabeled

COMMontheVTterminal.

3. Turnonthe terminalandaccesstheSetupDirectory.Setthefollowingparameterson



yourterminal:

Whentheseparametersareset,theStartupscreenwilldisplay.Proceedto“Connectingto

theNetwork”onpage 3‐20.

Figure 3-10 Connecting a VT Series Terminal

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

1 DB9 female connector 4 DB25 female connector

2 Serial interface cable 5 VT terminal or PC with VT emulation application

3 DB9 male Console port connector

Console

ÂÃ Á À

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 69 70

No comments

Enterasys Networks C2K122-24 User Manual Page 48