Enterasys-networks Network Ethernet Adapter User Manual download pdf (Page 26)

Powering Up

2-4 Installation and Connection

Detection Sequence

OnceacompliantloadisattachedtotheoutputRJ45connector,

thegreen“CONNECT”LEDwillilluminate.

Shouldtheloadbenon‐compliant,thentheLEDswillblinka

codesignifyingthecausefornon‐detection.

Detection Failure Codes

1. Incorrectresistivesignature–Thegreen“CONNECT”and

red“FAULT”LEDswillblink3times.

2. Incorrectcapacitivesignature–Thegreen“ON”LEDwill

blink3times.

3. IncorrectVoffset–Thegreen“CONNECT”andgreen“ON”

LEDswillblink3times.

4. Unstablecurrentmeasurement–Thegreen“ON”LEDwill

blink3times.

5. Lowvoltagesensedduringdetection(overload)–Thered

“FAULT”LEDwillblink3

times.

AftertheLEDsblink3timestheBL‐69551ENTwillcontinueto

trytodetectavalidload.Therefore,untilthecorrectloadis

applied,theLEDswillcontinuetoblink.Ifthereisanopen

circuitconnectedtotheoutputRJ45,thentheLEDswillnotblink

butthe

BL‐69551ENTwillcontinuetotrytodetectavalidload.

Fault Sequence

Shouldtherebeafaultsuchasanoverloadorshortcircuit,then

thered“FAULT ”LEDwillilluminate.Thered“FAULT”LED

willilluminatefor2secondsandthengooffasthepowersupply

triestore‐detect

avalidload.Ifthereisaproblemindetecting,

theLEDwillindicatewhatiswrongwiththeloadasperthe

codesinthesectionabove.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

No comments

Enterasys-networks Network Ethernet Adapter User Manual Page 26